P0214 - Cold Start Injector 2 Malfunction

The ECM detected a fault in cold start injector 2 control.

Code Overview

The ECM detected a fault in cold start injector 2 control.

Common Causes

• Failed solenoid or control component
• Damaged wiring or connector
• Control-module or driver issue

Diagnostic Steps

1. Inspect the related connector and wiring
2. Check for command signal and power supply
3. Look for companion fuel-system or timing-control codes

Likely Repairs & Cost Guides

Use test results to confirm the fault before pricing the repair.

Related OBD Codes

Browse the closest code-family pages when the same fault pattern often shows up nearby.

Next Steps

Move from the code to a diagnosis path, then into repair pricing once the fault is confirmed.